Table des Matières
Publicité
various types of commercial solvents.
• All bearings etc, in this tool are lubricated with a sufficient amount of high grade lubricant
for the tools lifetime under normal operating conditions, therefore no further lubrication is
required.
8. REPLACING THE CARBON BRUSHES
Remove and inspect the carbon brushes after periods of extended use. Replace them when
they eventually wear down. The brushes should be kept clean and free to slide up and down
inthe holders. Both brushes should be replaced at the same time as a pair.
Only use identical brushes from your Clarke dealer.
Use a screwdriver to remove the brush holder covers from the machine body.
Draw out the worn brushes and insert new ones before replacing the brush holder caps.
9. STORAGE
1. Make sure that the tool is stored in a clean, dry place, out of reach of children when not
in use.
2. Always store the impact wrench and its sockets in the case supplied.
10.
Disposal.
The machine, accessories and packaging should be sorted for environmental-friendly
recycling. The plastic components are labelled for categorized recycling. Do not dispose of
power tools into household waste! According the European Guideline 2012/19/EC for Waste
Electrical and Electronic Equipment and its implementation into national right, power tools
that are no longer usable must be collected separately and disposed of in an environmentally
correct manner.
13
Publicité
Table des Matières
