Electrical Connections - Raider RD-EIW05 Mode D'emploi

1.4.2. Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired.
1.4.3. Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
1.4.4. Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
1.4.5. Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained power
tools.
1.4.6. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
1.4.7. Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed. Use
of the power tool for operations different from those intended could result in a hazardous
situation.
2. SERVICE
1. When necessary, have your power tools serviced or repaired by a qualified person using
identical replacement parts. This will ensure that the safety of the power tool is maintained.
3. IMPACT WRENCH SAFETY INSTRUCTIONS
3.1. Use the wrench correctly. Only use the impact wrench in the manner and for the
functions described in these instructions.
3.2. Changing Sockets. Always disconnect the machine from the power supply when
changing sockets etc. Use only Impact Wrench sockets....DO NOT use standard sockets.
3.3. Achieve the correct torque. Always finish tightening wheel nuts with a torque wrench
or suitable spanner to the wheel-nut torque as recommended by the vehicle manufacturer.
3.4. Avoid excessive use of the wrench. When tightening a nut or bolt, never allow the
wrench to impact more than 8 times - to avoid over tightening - 3 to 4 impacts is sufficient.
3.5. Care of the mains cable. Keep the mains cable well away from the machine and ensure
an adequate electrical supply is close at hand so that the operation is not restricted by the
length of the cable.
3.6. Use outdoor extension leads. If working outdoors, always use an approved cable
extension suitable for the power rating of this tool (see specifications), the conductor size
should also be at least the same size as that on the machine, or larger. When using a cable
reel, always unwind the cable completely.

4. ELECTRICAL CONNECTIONS

This product is provided with a 13 amp, 230 volt (50Hz), BS 1363 plug, for connection to a
standard, domestic electrical supply. Should the plug need changing at any time, ensure that
a plug of identical specification is used.
WARNING: THIS APPLIANCE IS OF DOUBLE INSULATED DESIGN
No earth conductor is provided. The two wires in the mains lead should bewired in
accordance with the following colour code:
Blue — Neutral
Brown — Live
Connect the BROWN coloured cord to the plug terminal marked a letter "L" Connect the
BLUE coloured cord to the plug terminal marked a letter "N" If this appliance is fitted with a
plug which is moulded on to the electric cable (i.e. non-rewireable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a danger of
electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
11