Electromagnetic Fields (Emf); Using The Appliance - Philips QC5130/40 Mode D'emploi

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
Charging
Do not charge the appliance for more than 24 hours.
Charging takes approx. 8 hours.
When the appliance is fully charged, it has an operating time of 60 minutes.
1 Make sure the appliance is switched off.
2 Insert the appliance plug into the appliance.
3 Put the adapter in the wall socket.
, The green CHARGE light starts to flash to indicate that the appliance
is charging.
When the batteries are fully charged, the green CHARGE light burns
,
continuously. After 30 minutes the CHARGE light goes out to save energy.
Optimising the lifetime of the rechargeable batteries
Discharge the rechargeable batteries completely twice a year by letting the
motor run until it stops. Then fully recharge the batteries.
Corded clipping
If the batteries are low, you can also use the appliance from the mains.
Only use the appliance from the mains when the rechargeable batteries
are almost empty.
1 Switch off the appliance.
2 Connect the appliance to the mains and wait a few seconds before
you switch it on.
If the rechargeable batteries are completely empty, wait a few minutes
before you switch on the appliance.

Using the appliance

Note: Make sure your hair is clean and dry. Do not use the appliance on
freshly washed hair.
ENGLISH
7