Stand-Off Guide; Drag Cutting 40 Amp - ESAB PT-38 Manuel D'instructions

sEcTIoN 4
WaRNINg
4.1

stand-off guide

Use to maintain a constant stand-off distance. Attach optional stand-off guide assembly by removing the retaining/shield
cup and installing the stand-off guide assembly.
Guide against
straight edge or
free-hand cut.
Figure 4-4. Installation and operation of stand-off guide
4.2

Drag cutting 40 amp

For cutting thin material, under 3/8" (9 mm), insert low current gas baffle, electrode, 40 amp drag nozzle, and standard
retaining/shield cup. Set current level to 40 amps and begin cutting.
DRag cuTTINg, EvEN WITh loWER cuRRENT lEvEls MaY sIgNIFI-
caNTlY REDucE ThE lIFE oF ToRch coNsuMaBlEs. aTTEMPTINg
To DRag cuT WITh hIghER cuRRENTs gREaTER ThaN 40 aMPs
MaY causE IMMEDIaTE caTasTRoPhIc coNsuMaBlE DaMagE.
Gas Baffle (30-70 Amp)
Electrode 40 Amp Drag Nozzle
21
oPERaTIoN
Stand-off guide
assembly
Retaining/Shield Cup