Lenz DIGITAL PLUS SILVER 21 Mode D'emploi page 27

27
The push-pull train control is activated in CV51, Bit 4 (3) and Bit 5 (4). The stopping time at the end
of the track is set in CV54 (1 to 255 sec).
E
4.9 Allocating function outputs to the functions of the digital system (mapping)
Here you can define which function of the digital system is used to switch the function outputs A, B,
C and D on or off. The outputs A, B and C can be allocated to function F0 (direction-dependent) or
functions F1 to F8 as desired. Output D can be allocated to function F0 (direction-dependent) or
functions F1 to F12 as desired.
This is allocated in CVs 33 to 46.
4.10 Lighting effect at function outputs
The lighting effect for the function outputs A and B is set in CV60 and for the function outputs C and
D in CV62. If you wish to switch the effects with a function of the digital system, you can make the
allocations to functions F1 to F8 in CV61 (for function outputs A and B) and CV64 (for function
outputs C and D). The effects available are shown in the table of the supported CVs further below.