Ermax 7702044 Notice De Montage page 2

Fitting kit
- 4 3,513 TCC screws.
- 2 beleved spacers
Assembly
- Remove both saddles, the rear indicators, the license plate and the rear seat unit.
- Cut away the number plate support by following the toolbox outlines.
- Position the undertray and fix it using the four provided screws.
- Replace the rear seat unit and both saddles.
- Rivet the license plate on the support.
- Replace the four fixing screws of the footrests by BTR screws of the same diameter.
- If necessary, fix the plate with the supplied beleved spacers.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
FITTING INSTRUCTIONS
« CAUTION »
« UNDERTRAY »
YZF R1 1998/1999
Original tyre in 190/50 ZR 17.