Maintenance And Storing; Technical Specification; Accessories - DRAMINSKI GRAIN MASTER Mode D'emploi

MAINTENANCE AND STORING

Quick removal of grinded material after each measurement (especially with high
humidity content) favors long lasting device operation.
After each season, it is required to clean friction components and threaded shank
thoroughly, using a brush and compressed air.
Meter must be stored completely dry to guarantee its durability. Moreover, metal
components may be preserved using very thin layer of machine oil. Layer must be
removed before further use.
The device must be stored in a dry and warm place.

TECHNICAL SPECIFICATION

method of chamber filling
power supply
operation time
power input
measurement control
readout display
indication resolution
data storage
calibration
measurement temperature
temperature compensation
storing temperature
weight
dimensions

ACCESSORIES

1. Alkaline 9V battery (installed).
2. Socket wrench with 24mm socket
3. Cleaning brush
4. Operating manual
Dramiński company informs that the device may not be used for grain trade settlements
and is intended for in-house use or approximate determination of moisture content.
Manufacturer will offer its knowledge and advice and reserves the right to design
changes, and software improvements without notice.
manual, using fixed measure
alkaline battery - 9V
approx. 20 hours of constant operation, battery
discharging automatically signaled
20 mA average
single chip microcomputer
alphanumeric LCD, 2 x16 - characters
0,1 %
limit measurement error ± 1.0% within 10% humidity
content range, over 10% ± 1.2%.
flash memory
RS 232 type connector, encoded file
10° C to 35° C (accuracy 1° C)
automatic from 10° C to 35° C
min. +5° C, max.+45° C
1400 g
21cm x 11cmx 11cm
Manufacturer:
DRAMIŃSKI
Ul. Owocowa 17
10-860 Olsztyn
Poland
Phone: +48 89 527 11 30
Fax: +48 89 527 84 44
e-mail: draminski@draminski.com
www.draminski.com
7