DRAMINSKI GRAIN MASTER Mode D'emploi page 20

The number in brackets is the number of samples needed for the measurement.
t,u"
Using " buttons, you can select the required grain species.
MEASUREMENT PROCESS
In order to perform a measurement, it is required to carry out the following
activities:
1. Fill the test chamber with proper volume of tested grain, using the socket
wrench.
It is usually enough to fill the chamber with single measure of grain (approx. 9
ml). Two measures are required for maize measurement only. The principle is to
use a flat filled socket (without a pile on top).
Tested sample must be properly taken and purified. Careful measurement of
grain volume will give correct result.
Improper measurement of grain volume (too much or too small) will result in
unnecessary inaccurate readings.
2. Put the test chamber cover into the threaded shank and turn it manually several
times to - light resistance.
3. Put on the socket wrench into the hexagonal shank and tighten it in short strokes
to complete resistance, until it is locked with protruding pin. During tightening, it
is necessary to hold the device steady on the surface or to hold the meter in your
hand.
4. After performing above activities, check if the display shows proper grain species
and start the measurement process by pressing green „OK" button.
- text and progress state (stars) will appear, e.g.:
5. After finishing measurement cycle, lasting approx. 20 seconds, the following
message with results appears:
6. Last three results are stored in the memory. Press „
average value of last three measurements and store it as a final result.
4
Rape
[1]
Rape
Wait
Rape
∗∗∗∗...
Rape
11,6% 22,0° C
t
" button to read the