Home Page Configuration; Connection To An External Thermostat - CASATELLI FILIPPO 12 E1C Généralités - Avertissements - Installation - Entretien

8

HOME PAGE CONFIGURATION

operation.
Before starting, the stove must be powered on by pressing the safety switch on the back:
a) Use the
b) Select the password "7" with the
c) Scroll with the
d) Press the key and enter the value "54" with the
e) Press
f)
g) To modify, press the
h) Press
TWO DIFFERENT CONFIGURATIONS CAN BE SET:
CONFIGURATION 1 (default)
The stove will modulate the power according to the ambient temperature read by the probe on board.
set room temperature.
CONFIGURATION 2

8.1 CONNECTION TO AN EXTERNAL THERMOSTAT

The stove can be connected to a thermostat or chronothermostat.
The external thermostat must be connected to the relevant terminals on the electronic board which are jumpered
in the factory. Disconnect the jumper, therefore, and connect the two thermostat contacts in its place.
It is important to set the stove to
the chronothermostat is in the "called" state. This operation is also necessary in the event of a power failure or
To avoid overlapping operating time bands, we recommend disable the stove timer (set to OFF).
arrow keys to go to the set-up menu
keys and select the submenu
004778350 - 16/07/2020
and press the key;
key;
[30] --0
; "
keys;
keys;
47