Setting The Timer; Drip Stop Function; Cleaning And Maintenance; Cleaning After Every Use - Philips HD7769 Mode D'emploi

1 Open the water reservoir lid and fill the water reservoir with the required amount of cold water (Fig.
7).
2 Open the filter basket holder (Fig. 14).
3 Place a paper filter (type 1x4 or no. 4) or the permanent filter in the filter basket.
4 Put pre-ground coffee in the paper filter or in the permanent filter.
5 Close the filter basket holder.
6 Put the jug in the appliance (Fig. 8).
7 Press the on/off button (Fig. 9). The display lights up.
8 Press the strength select button (Fig. 10).
9 Turn the control knob to choose the pre-ground coffee setting (Fig. 11). The pre-ground coffee icon
lights up.
10 Press the center of the control knob to confirm (Fig. 6).
11 Then press the center of the control knob again to start the brewing process (Fig. 6).
12 Wait until the coffeemaker has stopped beeping before you remove the jug.
Note: After brewing, coffee drips from the filter basket for several seconds.
13 The appliance keeps your coffee hot until it switches off automatically. If you do not need your
coffee to be kept hot, press the on/off button to switch off the appliance.

Setting the timer

The timer enables you to program the time at which you want the brewing process to start. Make sure
that all steps of brewing coffee with either preground coffee or coffee beans have been taken before
setting the timer.
1 Press the timer button (Fig. 17) and the timer icon will appear on the display. The hour indication
flashes to indicate that you have to set the hour.
2 Turn the knob to set the hour (Fig. 18).
3 Press the center of the control knob to confirm the hour (Fig. 20). The minutes indication starts to
flash to indicate that you have to set the minutes.
4 Turn the control knob to set the minutes (Fig. 19).
5 Press the center of the knob to confirm the minutes and the time set (Fig. 20). The timer is set and
the brewing process will start at the preset time.
Note: To cancel the timer, simply press the timer button again and the timer icon will disappear from
the display.

Drip stop function

The drip stop function enables you to remove the jug from the coffeemaker before the brewing
process is finished. When you remove the jug, the drip stop stops the flow of coffee into the jug.
Note: The brewing process does not stop when you remove the jug. If you do not put the jug back in
the appliance within 20 seconds, the filter basket overflows.

Cleaning and maintenance

Cleaning after every use

Never immerse the appliance in water or any other liquid, nor rinse it under the tap.
English
11