GreenWorks Elite ST-140-AT Guide D'utilisation page 12

ASSEMBLY
W A R N I N G
If any parts are damaged or missing, do not operate this product until the parts are replaced. Use
of this product with damaged or missing parts could result in serious personal injury.
W A R N I N G
Do not attempt to modify this product or create accessories not recommended for use with this
string trimmer. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
W A R N I N G
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
ATTACHING THE GUARD
NOTE: Install the guard before the attachment is connected to the lower shaft.
1. Remove the battery.
2. Invert the string trimmer to access the trimmer head.
3. Using a Phillips head screwdriver, remove the pre-installed screws from the trimmer head.
4. Place the guard on to the trimmer head and slide the guard onto the head by following the
track on the head.
5. Align the screw holes on the guard with the screw holes on the trimmer head.
6. Insert the screws into the trimmer head, fastening the guard in place.
GUARD
(See Figure 2.)
11
SCREW
GUARD PLATE
Fig.2