EdilKamin Evolution CHIC Installation, Usage Et Maintenance page 23

ELITE covering assembly
• Equippment and small items:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8 Ø 6 flat washers
- the 2 M6x25 screws and the 2 M6
flat washers are to be used for fixing
the ceramic top panel (22).
- the 2 M6x12 screws and the 2 M6
flat washers are to be used for fixing
the ceramic bottom panel (22).
- As for the 4 spacers and the 4
washers, proceed as follows:
Insert the 4 spacers in their respective
4 holes on the cast iron top. Put the
ceramic top to verify the correct
flatness.
If necessary, insert a flat washer
between the silicone spacer and the
cast iron top, in order to bring the
ceramic top to level with the stove.
detail "X"
2 screws
The stove is delivered fully assembled. If however you need to dismount the covering, proceed as follows:
Unscrew the rear (54) and the two bars (74) dismount the cover, the cast iron top (72) and the ceramic top (28).
Remove the metal sides (80) and, if necessary, the aluminium bars (83) on the base.
Remove the front panel (22) and then the top rear panel (24) from the guides on the grille.
Loosen the two screws to remove the bottom front panel (22) as shown in detail "X".
To assemble, proceed in reverse order.
- 23
-