Philips Lumea SC2001 Manuel D'utilisation page 33

Note: Stop using the appliance when it is no longer
possible to clean the light exit window or the body
attachment.
1 Switch off the appliance, unplug it and let it
cool down.
Note: The light exit window becomes hot during
use. Make sure it has cooled down before you
clean it.
2 To remove the body attachment, put your
fingers in the recesses at the top and bottom
and pull gently. The attachment should come
off easily.
3 Moisten the soft cloth supplied with the
appliance with a few drops of water and use it
to clean the following parts:
- the light exit window
- the outside surface of the body attachment
- the metallic frame inside the body attachment
Note: If water does not clean effectively, use a few
drops of high-percentage alcohol to clean the parts
mentioned above.
Note: A contaminated light exit window can
look like this picture. Make sure you clean the
appliance before and after each use and, if
necessary, also during the treatment according to
the instructions in this section.
4 If necessary, clean the outside of the appliance
with the dry soft cloth supplied with the
appliance.
English
33