Philips Lumea SC2001 Manuel D'utilisation page 27

more pressure on the appliance to push in all contact
switches.
Note: Bony areas like shinbone, ankles or ribs are
more sensitive than other areas of the body. When
you press the appliance hard onto these areas, the
skin can be more susceptible to skin reactions like
irritation and redness. See section 'Possible side
effects and skin reactions' in this chapter. Press the
appliance onto the skin just hard enough to make
the 'ready to flash' light go on, but no harder.
7 Press the flash button to release a flash. After
the appliance has flashed once, release the flash
button.
Note: The visible light produced by the appliance
is the reflection of the flash on the skin and
is harmless to your eyes. It is not necessary to
wear goggles during use.
8 Let go of the flash button after the appliance
has flashed. For the next flash, repeat steps 5
to 8. After each flash it takes up to 3.5 seconds
until the appliance is ready to flash again.
Do not treat exactly the same area multiple times
during one session. This does not improve the
effectiveness of the treatment, but increases the
risk of skin reactions.
9 To avoid untreated areas, always make
sure there is some overlap with the previously
treated area when you place the appliance on
the skin.The effective light only comes out of
the light exit window with integrated UV filter.
Make sure the flashes are produced close to
each other. Ask somebody else to help you
English
27