Makita MLT100 Manuel D'instruction page 15

Miter gauge
1
2
4
3
008788
Use the miter gauge for the 4 types of cutting shown in
the figure.
CAUTION:
Secure the knob on the miter gauge carefully.
•
Avoid movement of the workpiece and gauge by
•
firmly securing
especially when cutting at an angle.
NEVER hold or grasp the intended "cut-off" portion
•
of the workpiece.
Use of miter gauge
1
2
3
009910
Slide the miter gauge into the thick grooves in the table.
Loosen the knob on the gauge and align to desired
angle (0° to 60°). Bring stock flush up against fence and
slide table, secure it with the clamp on the miter gauge
and feed gently forward into the blade.
Auxiliary wood facing (miter gauge)
008790
To prevent a long board from wobbling, fit the miter
gauge with an auxiliary fence board. Fasten with
bolts/nuts after drilling holes, but fasteners must not
protrude from the face board.
1. Cross cutting
2. Mitering
3. Bevel cutting
4. Compound
mitering
(angles)
the workpiece and
1. Groove
2. Miter gauge
3. Knob
Non-through cut
Turn off the tool and unplug it before any adjustment.
Remove the blade guard assembly from the riving
knife/spreader.
Adjust the riving knife/spreader to the RIVING KNIFE
POSITION as described earlier in the manual. Before
making a through cut adjust the riving knife/spreader to
the spreader position and install the blade guard
assembly and the side guards before operation.
WARNING:
Conducting a through cut without proper
•
guarding may result in serious personal injury.
Carrying tool
gauge,
009958
MAINTENANCE
WARNING:
Always be sure that the tool is switched off and
•
unplugged
inspection or maintenance.
Cleaning
Clean out sawdust and chips from time to time. Carefully
clean the blade guard and moving parts inside the table
saw.
Lubrication
To keep the table saw in tip-top running condition, and to
assure maximum service life, oil or grease the moving
parts and rotating parts from time to time.
Lubrication places:
Threaded shaft to elevate the blade
•
Hinge to rotate the frame
•
Elevation guide shafts on motor
•
Gear to elevate the blade
•
15
before attempting to perform