Makita MLT100 Manuel D'instruction page 11

Fig.1
1
1. The blade guard assembly item 1 is provided with two
on board antikickback pawls item 2. The pawls are
located on either side of the blade and can be stored
or put into operation independently for ease of
operation
008936
1
1. Item 1 illustrates the antikickback pawl on the right
side of the blade being lifted and placed into the pawl
holder located at the back of the blade guard
assembly.
2. In addition item2 illustrates the antikickback pawl on
the left side of the blade remaining in the operational
position.
008937
1
1. Item 1 demonstarates both antikickback pawls being
lifted and placed into the pawl holders located at the
back of the blade guard assembly for storage
008938
2
2 Fig.2
Fig.3
2
3
1. Item 1 indicates the location of the antikickback pawl
holders located at the back of the blade guard
assembly
2. Item 2 points to the arrow direction which should be
followed when taking the pawls out of the storage
position and placing them into operation
3. Item 3 indicates the direction of which the pawls
should be lifted when storing and placing them into
the antikickback pawl holders
008939
Storage of Blade Guards and Accessories
1
008759
009696
009913
11
1
Fig.4
1. Rip fence
(Guide rule)
2. Miter gauge
2
1. Push stick
1
1. Table saw blade
gurad assembly
and side gurd
storage
1