Factory Default Settings; Cabling - Atlantis PROFESSIONAL WebShare 141 WN Mode D'emploi

1.5 Factory Default Settings

Before you configure this WebShare Wireless Router ADSL2+, you need to know the
following default settings:
 Username: admin
 Password: atlantis
 IP address: 192.168.1.254

Subnet Mask: 255.255.255.0
 DHCP Server: enable (from 192.168.1.100 to 192.168.1.199)
 WAN=PPPoA Routing, VPI=8, VCI=35, VC-Mux
 ESSID= A02-RA141-WN, Channel=6, WEP/WPA=WPA-PSK
 WPA Pre-shared Key: WebShare141WN

1.6 Cabling

First you must connect the product to the ADSL line through the RJ11 cable you
have in equipment (in the port DSL), then connect to the RJ45 ports the PCs of
your Lan or others Switch. You can get to the Wireless Router through the different
client wireless compatible with the IEEE802.11b & IEEE802.11g standard. In the
end connect the AC Adapter to the Wireless Router ADSL2+ and then to the socket.
Once you‟ve checked all the connections and you‟ve switched on the Wireless
ADSL2+ Router the product will carry on immediately a autotest (60 seconds).
Finished this, the LEDs status will be the following:
LED
PWR
LAN 1-4
WLAN
ADSL
PPP/INTERNET
The Led ADSL, if suitably connected, at first will be flashing and then it will remain
fixed. You have to read Note (into section 2.2) in order to solve this problem.
One of the most common causes of problem is bad cabling or ADSL line(s). Make
sure that all connected devices are turned on. On the front panel of your router is a
bank of LEDs. Verify that the LAN Link and ADSL line LEDs are lit. If they are not,
verify if you are using the proper cables. Make sure that all devices (e.g.
telephones, fax machines, analogue modems) connected to the same telephone line
as your router have a line filter connected between them and the wall outlet (unless
Lit green
Blinking green if any device is connected to the Router.
Lit or Blinking green
Lit or Blinking green
Lit red
Status
40