Factory Default Settings; Cabling - Atlantis PROFESSIONAL WebShare 111 WN Mode D'emploi

WLAN
Ethernet
LINE (RJ11)

1.5 Factory Default Settings

Before you configure this WebShare Wireless Router ADSL2+, you need to know the
following default settings:

Username: admin
 Password: atlantis

IP address: 192.168.1.254
 Subnet Mask: 255.255.255.0
 DHCP Server: enable (from 192.168.1.100 to 192.168.1.199)
 WAN=PPPoA Routing, VPI=8, VCI=35, VC-Mux
 ESSID= A02-RA111-WN, Channel=6, WEP/WPA=WPA2-PSK (AES)
 WPA Pre-shared Key: WebShare111WN

1.6 Cabling

First you must connect the product to the ADSL line through the RJ11 cable you
have in equipment (in the port DSL), then connect to the RJ45 ports the PCs of
your Lan or others Switch. You can get to the Wireless Router through the different
client wireless compatible with the IEEE802.11b & IEEE802.11g standard. In the
end connect the AC Adapter to the Wireless Router ADSL2+ and then to the socket.
Once you‟ve checked all the connections and you‟ve switched on the Wireless
ADSL2+ Router the product will carry on immediately a autotest (60 seconds).

WPS: Press 1-5 seconds to trigger WPS function.

Wireless ON/OFF Switch: Press over 10 seconds to
switch on wireless function. Press over 10 seconds
again for disable wireless function.
Connect an UTP Ethernet cable to one of the four LAN
ports when connecting to a PC or an office/home network
of 10Mbps or 100Mbps.
Connect the supplied RJ-11 cable to this port when
connecting to the ADSL/telephone network.
39