Factory Default Settings; Cabling - Atlantis WebShare 142WN Guide D'installation Rapide

1.5 Factory Default Settings

Before you configure this WebShare Wireless N ADSL2+ Router, you need to know
the following default settings:
 Username: admin
 Password: atlantis
 IP address: 192.168.1.254

Subnet Mask: 255.255.255.0
 DHCP Server: enable (from 192.168.1.100 to 192.168.1.199)
 WAN=PPPoA Routing, VPI=8, VCI=35, VC-Mux
 ESSID= A02-RA142-WN, Channel=6, WEP/WPA=WPA2-PSK (AES)
 WPA Pre-shared Key: WebShare142WN

1.6 Cabling

First you must connect the product to the ADSL line through the RJ11 cable you
have in equipment (in the port DSL), then connect to the RJ45 ports the PCs of
your Lan or others Switch. You can get to the Wireless Router through the different
client wireless compatible with the IEEE802.11b & IEEE802.11g standard. In the
end connect the AC Adapter to the Wireless Router ADSL2+ and then to the socket.
Once you‟ve checked all the connections and you‟ve switched on the Wireless
ADSL2+ Router the product will carry on immediately a autotest (60 seconds).
Finished this, the LEDs status will be the following:
LED
STATUS
LAN 1-4
WLAN
WAN
The Led WAN, if suitably connected, at first will be flashing and then it will remain
fixed. One of the most common causes of problem is bad cabling or ADSL line(s).
Make sure that all connected devices are turned on. On the front panel of your
router is a bank of LEDs. Verify that the LAN Link and WAN line LEDs are lit. If they
are not, verify if you are using the proper cables. Make sure that all devices (e.g.
telephones, fax machines, analogue modems) connected to the same telephone line
as your router have a line filter connected between them and the wall outlet (unless
you are using a Central Splitter or Central Filter installed by a qualified and licensed
electrician), and that all line filters are correctly installed in a right way. If line filter
Blinking green.
Blinking green/orange if any device is connected to the
Router.
Blinking/Lit green.
Lit green.
Status
45