Black & Decker BL1350DPC-P Guide D'utilisation Et D'entretien page 6

US IN G YO UR BL EN D ER (W IT HO U T I N FU SE R)
Important: Appliance should always have lid in place when in use.
Caution: Do not place blender jar onto base when motor is running.
Caution: Do not blend hot liquids.
1. Make sure appliance is OFF.
2. Place ingredients to be blended into jar. For best results, add ingredients
in the following order:
a. Liquids
b. Powders
c. Soft foods
d. Hard foods
e. Ice cubes last
Tip: When using frozen fruit, it is not necessary to also add ice.
3. Place lid on jar; make sure the pour spout and ingredient slot are closed.
4. Plug power cord into outlet. Press ON/OFF button. LED should turn a
solid color to signify the blender is in standby mode. After 2 minutes the
unit will automatically power off if no buttons are pressed.
Note: When in use, do not leave blender unattended. When using hard foods,
such as ice or cheese, keep one hand on the lid to keep blender in place.
5. Select the speed that best suits your desired task. (See SPEED CHART)
Important: Do not hold speed button. Simply press the desired speed, watch,
and press ON/OFF when the desired consistency is achieved. Holding the
button for longer than 30 seconds will cause the blender to enter an error
mode, with the LED blinking rapidly. Shut off unit to reset.
6. When blending thick mixtures, such as smoothies and milkshakes, use
the PULSE/Ice Crush button for several seconds, then release. Repeat to
mix ingredients and then run continuously until food has reached desired
consistency. Releasing pulse stops the blending and the unit returns to
STANDBY. You may use a spatula or utensil to move ingredients and thick
mixtures around in the blender jar, but only after stopping the blender.
Turn the blender OFF before using a utensil.
7. Open the ingredient slot to add ingredients while the blender
is running. Drop ingredients through the opening. (F).
Important: Do not remove the lid while the blender is running.
8. When finished, press ON/OFF to stop blending.
Make sure blades have completely stopped before
attempting to remove the blending jar from the base
(refer to TROUBLESHOOTING for any issues).
9. Press ON/OFF to power off and unplug the blender.
10. To remove the jar assembly: Grasp both the jar base and the handle and
rotate them together counter-clockwise. Then lift up.
11. Open pour spout to serve.
6
F