Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CL EA NI NG T IP S
• For quick cleanup, combine 1 cup warm water and a drop of liquid dish
soap in the blending jar.
• Cover and blend on Speed 2 for about 30 seconds.
• Discard liquid and rinse thoroughly.
Important:
• Do not place the jar parts in boiling liquids.
• Do not immerse the base in liquid. Wipe the base with a damp cloth and
dry thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and nonabrasive
cleaner.
Note: If liquids spill onto the base, wipe with a damp cloth and dry thoroughly.
Do not use rough scouring pads or cleansers on parts or finish.
TROU B LESHO OTIN G
Problem
Blender stops/
goes into
STANDBY mode
LED blinking
quickly
All LEDs blinking
quickly
(100 msec/time)
Possible Cause
Blending time exceeds
2.5 minutes.
Button held longer than
30 seconds.
Blender overheated or
button held longer than
30 seconds.
Solution
Re-select appropriate speed
setting to start blender.
Press On/Off button twice to turn
unit Off and On again.
Unit must be reset. Unplug to
reset. Let unit cool for at least 20
minutes
10
Publicité
Table des Matières
