Connecting Power; Ac Adapter; Battery Installation; Initial Calibration - OHAUS SL Serie Guide De L'utilisateur

Adventurer SL

2.5 Connecting Power

2.5.1 AC Adapter

Connect the AC Adapter to the wall outlet. Connect the plug to the receptacle on
the rear of the balance.
For use with CSA Certified (or equivalent approved) power source,
which must have a limited circuit output.

2.5.2 Battery Installation

Some Adventurer SL models operate with batteries. To install batteries, remove the
pan and its components.
To protect the cone from damage while installing batteries,
Remove the battery compartment cover from the bottom of the balance.
Install 4 AA (LR6) batteries in the compartment, aligning the batteries according
to the + and - symbols.

2.6 Initial Calibration

When the balance is first installed, it must be calibrated to ensure accurate
weighing. You will need appropriate calibration weights available before
beginning calibration. Refer to Section 5.4 for calibration weight information.
Refer to Section 3.5.1 for calibration instructions.
CAUTION:
do not rest the balance upside down.
EN-9