Hoffmann Garant 921401 Mode D'emploi page 56

GARANT Workbench with electric height adjustment
Error code
E004
en
E005
E006
E007
E008
E009
E010
E020
E021
E022
E030
E040
E049
E050
E051
E052
E053
E054
56
Possible cause
Internal electronics be-
coming too cold
Internal electronics too
cold
Internal electronics be-
coming too hot
Internal electronics too
hot
A temperature sensor is
defective
The calculated effi-
ciency of the device is
too low
Missing inverter
Charge error
No calibration
DC communications er-
ror
Cell voltage measure-
ment error
Battery flat
Voltage becoming too
low in one or more cells.
Voltage too low in one
or more cells
Voltage becoming too
high in one or more
cells
Action
Move the workbench to a
warmer location.
Move the workbench to a
warmer location.
Disconnect the battery from
the power supply. Move the
workbench to a cooler loca-
tion.
Disconnect the battery from
the power supply. Move the
workbench to a cooler loca-
tion.
Restart the battery.
If the fault still persists.
Restart the battery.
If the fault still persists.
Insert the mains plug into a
mains socket and fully
charge the battery.
Insert the mains plug into a
mains socket and fully
charge the battery.
Insert the mains plug into a
mains socket and fully
charge the battery.
Disconnect the battery from
the power supply.
The message will remain dis-
played even after 24 hours.
Instruction manual
Performed by
Trained person
Trained person
Trained person
Trained person
Hoffmann Group Customer
Service
Hoffmann Group Customer
Service
Trained person, Hoffmann
Group Customer Service
Trained person, Hoffmann
Group Customer Service
Hoffmann Group Customer
Service
Hoffmann Group Customer
Service
Hoffmann Group Customer
Service
Trained person
Trained person
Trained person
Trained person