From Vehicle To Wheelchair - Autoadapt CARONY Go! Manuel D'utilisation

5. FROM VEHICLE TO WHEELCHAIR

1. Drive up the wheel unit
Reverse the wheel unit towards the
swivelled out seat.
2
1
4. Adjust the height
Adjust the height of the wheel unit and level it to the rails
in the vehicle.
Adjust by pressing the seat lift button, marked 1, and
then moving the joystick back or forth.
6. Transfer the seat
Release the seat from the vehicle by pulling down the seat
release handle at the front of the seat.
Slide the seat over to the wheel unit until it locks at end
position.
Make sure that the seat release handle has returned
to original position and that the seat is unable to slide
backwards!
2. Disengage the motors
Disengage the motors by pulling the
handle, placed on the side of the
wheel unit, forward.
5. Lock
Push the wheel unit towards the rails in the vehicle.
The covers of the clutch open automatically. Push until
it connects properly to the vehicle rails.
Make sure the units have been properly connected by
trying to pull them apart.
Height adjust to
compensate move-
ment of weight!
7. Prepare for drive
Release the wheelchair from the vehicle by pulling both
lock handles placed at the front.
Adjust the seat height to lowest position (see fig. 4).
This is important for the balance of the chair.
Engage the motors!
3. Move the wheel unit manually
Push the wheel unit towards the seat
rails.
21