Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
100920 AD500 Install instruct
S S y y s s t t e e m m O O p p t t i i o o n n s s ( ( C C o o n n t t i i n n u u e e d d ) )
1. If not already in Programming Mode, connect by telephone or use the local
keypad. Enter the master password and access programming.
2. Press:
3. Enter the disconnect time in seconds (15-255).
4. Press:
5. Exit Programming Mode if all programming is complete.
S S y y s s t t e e m m U U t t i i l l i i t t i i e e s s
Several utility commands are available for the system. Utilities can be used to clear
memory, display system information, and control the relays.
Display Unit Number
In multi-unit installations the unit number of each AD-500 can be displayed.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Press:
3. The display will show the unit number for three seconds.
4. Exit Programming Mode if all programming is complete.
Manual Control of the Relays
For servicing or testing, each relay output can be controlled manually from the
local keypad while in Programming Mode.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Enter a command to control a relay:
• Press
to latch Relay Channel "A"
• Press
to latch Relay Channel "B".
• Press
to release Relay Channel "A"
• Press
to release Relay Channel "B".
3. The display will show the unit number for three seconds.
Deleting Database Entries
Sections of the database can be deleted individually. Exercise care when using
these commands, their effect cannot be reversed.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Enter a command to delete database selections:
• To delete all resident data:
• To delete all entry codes press:
3. Exit Programming Mode if all programming is complete.
Total Memory Reset
This command will erase all data and restore the factory settings.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Press:
3. Exit Programming Mode if all programming is complete.
20
1/14/06
10:39 AM
Page 20
Publicité
Table des Matières
