Entry Code Length - NuTone AD-500 Directives D'installation

100920 AD500 Install instruct
E E n n t t r r y y C C o o d d e e P P r r o o g g r r a a m m m m i i n n g g
An entry code is a number entered at the local or remote keypad to request
access. Up to 500 entry codes from two to six digits in length can be set. All codes will
be the same length. The factory setting allows the entry code to activate. Relay Channel
"A" or "B" depending on which keypad the code is entered on. Each entry code can be
set to restrict which relay activates. Entry codes can also be set to
toggle the relay output (output latches on the until the next time a toggle entry code is
entered). Each entry code can be set for unlimited or limited number of uses.
Changing the Entry Code Length
The factory setting for the entry code length is 4 digits. It can be set to 2-6 digits.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press:
3. Enter the entry code length (2,3,4,5, or 6).
4. Press:
5. Exit Programming Mode if all programming is complete.
Adding an Entry Code
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press:
3. Enter the entry code.
4. Press:
5. Enter the entry code again.
6. Press:
7. If access to both relays is OK for this code, and the number of uses is
unlimited, skip to Step 12.
8. Enter the number for the relay output(s) that this entry code will be allowed
to activate or for toggle operation:
• Enter 1 for Relay "A" • Enter 2 for Relay "B" • Enter 3 for Relays "A" & "B"
• Enter 4 to toggle Relay "A" • Enter 5 for to toggle Relay "B"
9. Press:
10. If the number of uses is unlimited , skip to Step 12.
11. Enter the number of uses allowed (1-250).
12. Press:
13. Exit programming Mode if all programming is complete.
Modifying an Entry Code
Once entry codes have been set, they can be modified to change the relay(s) to
activate or the number of uses permitted.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press:
3. Enter the entry code.
4. Press:
5. Enter the number for the relay output(s) that this entry code will be allowed
to activate or for toggle operation.
• Enter 1 for Relay "A" • Enter 2 for Relay "B" • Enter 3 for Relays "A" & "B"
• Enter 4 to toggle Relay "A" • Enter 5 for to toggle Relay "B"
6. Press:
7. If the number of uses is unlimited, skip to Step 9.
8. Enter the number of uses allowed (1-250)
9. Press:
10. Exit programming Mode if all programming is complete.
Deleting an Entry Code
Entry codes can be deleted individually.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press:
3. Enter the entry code to delete.
4. Press:
5. Enter the entry code to delete again.
6. Press:
7. Exit programming Mode if all programming is complete.
16
1/14/06 10:39 AM Page 16