Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
100920 AD500 Install instruct
P P r r o o g g r r a a m m m m i i n n g g O O v v e e r r t t h h e e T T e e l l e e p p h h o o n n e e
The system can be programmed using a TouchTone
telephone's keypad will act similar to the AD-500's local keypad.
Connecting with a Telephone
1. Place a call to the telephone number of the line that the AD-500 is
connected.
2. The AD-500 will answer and sound a tone for about
3. After the tone, enter the master password, then press # (factory
setting is 123456). If the password is correct, the system will sound
two short beeps. For multi-unit installations, enter the unit
number then # before entering the password.
4. Programming commands can now be entered from the telephone's
keypad. Refer to the following sections of this manual for
programming step details.
When programming over the telephone, each programming step consists
of entering programming data using the keypad. The system will sound
beeps over the telephone to indicate correct or incorrect entries.
• After a correct entry, two short beeps will sound.
• After an incorrect entry, a long beep will sound.
• After the complete programming step has been entered correctly
three short beeps will sound.
Re-entering a Command After a Mistake
If an incorrect entry, or an incorrect key is pressed during programming,
press
and start the programming step over again.
Exiting Programming Mode
1. Press:
!
NOTE: The AD-500 will automatically exit Programming Mode
after five minutes of programming inactivity.
P P r r o o g g r r a a m m m m i i n n g g f f r r o o m m t t h h e e L L o o c c a a l l K K e e y y p p a a d d
The system can be programmed using a local keypad on the faceplate
of the AD-500. The display will show the programming information.
!
NOTE: When entering text, programming the AD-500 from a
computer is the preferred method
Accessing Programming from the Local Keypad
1. Press
&
keys at the same time, then release.
2. The display will show [PASSWORD:].
3. Enter the master password (factory setting is 123456).
4. Press:
5. If the password is correct, the display will show [ENTER
FUNCTION:].
6. Programming commands can now be entered on the local keypad.
Refer to the following sections of the manual for programming step
details.
Re-entering a Command After a Mistake
If an incorrect entry, or an incorrect key is pressed during programming,
to clear the keypad press
again.
Exiting Programming Mode
1. Press:
!
NOTE: The AD-500 will automatically exit Programming Mode
after five minutes of programming inactivity.
12
1/14/06
10:39 AM
Page 12
TM
telephone. The
⁄
second.
1
2
and start the programming step over
Publicité
Table des Matières
