Hoover H3TFS Mode D'emploi page 60

WARNING:
Don't touch the display (and the Touch
Control) while inserting the plug because
the machines calibrates the systems
during the first seconds: touching the
display, the machine couldn't work
property. In this case, remove the plug
and repeat the operation.
PROGRAMME selector with OFF
position
When the programme selector is turned
the display lights up to show the settings
for the programme selected.
For energy saving, at the end of the
cycle or with an inactivity period, the
display level contrast will decrease.
N.B.: To switch the machine off, turn
the programme selector to the OFF
position.
l
Press the START/PAUSE button to start
the selected cycle.
l
Once a programme
programme selector remains stationary on
the selected programme till cycle ends.
l
"End" will appear in the display at the
end of the program and the DOOR
LOCKED light will go off, it is now
possible to open the door.
l
Switch off the washing machine by
turning the selector to OFF.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
is selected the
60
l
Press to start the selected cycle.
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
ADD OR REMOVE ITEMS AFTER THE
PROGRAMMES HAS STARTED (PAUSE)
l
Press and hold the START/PAUSE
button for about 2 seconds (some
indicator light and the time remaining
indicator will flash, showing that the
machine has been paused).
l
Wait until the DOOR LOCKED light has
gone out before opening the door.
l
After you have added or removed items,
close the door
START/PAUSE button (the programme
will start from where it left off).
CANCELLING THE PROGRAMME
l
To cancel the programme, set the
selector to the OFF position.
l
Wait 2 minutes until the safety device
unlocks the door.
DELAY START button
l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Select the required programme.
- Press the delay start button once to
activate it (h00 appears on the display)
and then press it again to set a 1 hour
delay (h01 appears on the display). The
pre-set delay increases by 1 hour each
time the button is pressed, until h24
appears on the display, at which point
pressing the button again will reset the
delay start to zero.
and press the