Use; Electronic Control; Power Unit; Infrared Remote Control - GoodHome hyana 500W Mode D'emploi

Use

REGULATION AND OPERATION
The appliance is designed to heat rooms. When operating normally, the
surface of the appliance becomes very hot and may cause burns. Avoid
contact with parts of the body. Pay particular attention when children
are present.
Keep combustible or flammable materials or pressure vessels (e.g. spray
cans, fire extinguishers) at least 50 cm from the appliance. Do not vaporise
any type of substance on the surface of the appliance.
Do not wet the electronic control unit with water or other fluids. If this
occurs, disconnect the mains power supply and allow the appliance to
dry completely.
When the appliance is installed at high altitude, the air will be hotter than
the set temperature.
Possible traces of oil noted on the bottom of the radiator during mounting
or the first times you turn the appliance on may be left from the fabrication
process. Clean the part with proper precautions at intervals of a couple
of days. If the problem reoccurs, follow the instructions in Chapter
Remote control.
In cold conditions, the radiator may emit metallic sounds when turned on.
This is due to the expansion of the materials.
PHASE=BROWN/RED
NEUTRAL=GREY/BLUE
PILOT WIRE=BLACK
Appliance cable
Case 1: Installation
without Pilot Wire
Case 2: Installation
with Pilot Wire

ELECTRONIC CONTROL

Remote Control
PLUS button
LCD
MODE button
IR transmitter
}
PHASE
Household mains
NEUTRAL
Two possible cases
Terminate and insulate
the wire
Connect to the Pilot Wire
control unit or transmission box
IR transmitter
MINUS button
OK / WINDOW
STAND-BY button
Open Window
Keypad Lock
Standby Mode
Low Battery

POWER UNIT

LED 2
REMOTE CONTROL

INFRARED REMOTE CONTROL

The remote control communicates with the appliance by infrared rays.
For efficient communication, point the remote control at the receiver on
the appliance (Fig. 10). The distance between the remote control and the
receiver must not be more than 2 m.
The appliance responds to the commands received from the remote
control with a beep.
30
Chrono presets
Children Safety
Operating modes
Chrono program
time bar
Clock / Temperature
set point
Chrono temperature Set
Days of the Week
IR receiver
STAND-BY button
LED 1
OK / WINDOW