Nyrius ARIES Prime Mode D'emploi page 9

9. If all is operating normally, the POWER LED and INFO/CHANNEL LED will be SOLID BLUE. Please
refer to the chart below for detailed LED and OSD transmitter/receiver alert descriptions:
MODE
STANDBY
Power-save mode
During 15-20 second
WARM-UP
warm-up
System not able to establish
SEARCHING
link after 80 seconds (see
CHANNELS
Notes A and D)
No input from selected
source (See Note B)
WIRELESS
Video format not
MODE
recognized (See Note C)
Video format is recognized
NOTES
A. If the system is unable to establish a connection within 80 seconds, the connection has
been lost or the Transmitter is out of range. Verify the distance between the Transmitter and
Receiver. The maximum video transmission range for 1080p content is up to 30ft. in line of
sight (LOS). The minimum range is 6.5 ft.
B. Please confirm that the computer is powered ON and that HDMI OUT has been selected; check
that HDMI cable is properly connected.
C. If no video is displayed and OSD message states "NOT SUPPORTED FORMAT", then the video
frame rate from the computer is NOT supported. See " Supported Resolution" section to
change resolutions.
D. If you have more than one pair of each Transmitter/Receiver, each pair should be at least 6.5
feet away from each other. If both pairs of Transmitter/Receiver are in the same room, the
suggested the distance between the two is a minimum distance of 6.5 feet.
SETUP
STATUS
- 9 -
POWER STATUS
LED LED
Solid RED OFF
Flashing
Flashing
BLUE
Flashing
Flashing
BLUE
Flashing
Solid BLUE
quickly
Flashing
Solid BLUE
slowly
Solid
Solid BLUE
BLUE
OSD DISPLAY
4 Levels
looping -
Searching
Alternates
between
images on
OSD
-