Mounting The Receiver - Nyrius ARIES Prime Mode D'emploi

MOUNTING THE RECEIVER

1. Cut out the DRILLING TEMPLATE on page 19
and tape it to the wall in the location that you
would like the Receiver installed.
2. Pre-drill the holes in the marked location.
3. Insert the two supplied Anchors into the
pre-drilled holes.
4. Insert two screws into the anchors and
tighten until the screws only stick out about
an 1/8 inch away from the wall.
5. Locate the wall mounting holes on the back of
the Receiver. Slide the holes over the screws
sticking out of the wall to mount into place.
PC / LAPTOP
CONNECTING THE RECEIVER TO HDTV
1. Connect the HDMI cable to the HDMI Output of the receiver and to your HDTV television or HD
projector.
2. Connect the power adapter to the DC Input of the Receiver and into a wall outlet. When the
unit is successfully connected, the Power LED indicator on the POWER button lights up
in BLUE.
SETUP
- 6 -
(DRILLING
TEMPLATE)