Start; Throttle Trim; Steering Trim - Carson Mercedes Benz Unimog U300 Mode D'emploi

START

1. First switch on the transmitter.
2. No you're ready to activate the model.
To do this, push the main switch (power) on the underside of the
model to the "ON" position.
If the wheels start to turn, trim them in the opposite direction
using the throttle trim.
ON
OFF
1

THROTTLE TRIM

If RC model moves on its own accord when throttle trigger is in
neutral, adjust throttle trim.

STEERING TRIM

When the RC model does not run straight, adjust the steering trim.
Allow the model to move without adjusting the steering so that
you can establish the direction of travel and correct it by pushing
the steering trim in the opposite direction from the direction in
which the RC fork lift is moving.
The engine and warning sounds can also be switched on using a
separate switch.
To switch off after use, switch the model off, and then the
transmitter.
Power
2
Warning sounds
Engine sounds
Wind rope
When the model is
going backwards
When the model
is going forwards
17 // GB