Attaching The Device; Inserting The Battery; Rhythm Pattern List - Korg GM-1 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Features on this device
En
1. SYNC button (Hold down: Mute)
2. MODE button (Hold down:
Power)
3. Display
4. Jog Switch
Operate the jog switch by sliding
it in the direction of the arrow.
5. Ear cap
Attach the included ear cap to
the GM-1.
6. Ear clip
Attach the GM-1 to your left or right ear.

Attaching the device

Open the ear clip, and move the round part on the tip to match the ear
onto which you'll attach the GM-1. Place the GM-1 on the hollow part
of your ear around the ear hole, and close the ear clip to attach it.
For the le ear
For the right ear
The round part can rotate a maximum of 220
degrees. It will break if you attempt to rotate it
fartherthan this.
As this a small and lightweight device, there is
a risk that small children may place it in their
mouth and ingest it. Keep the device out of
reach and store it away from small children.

Inserting the battery

1. Slide the lid open.
Make sure that the GM-1 is turned off before replacing the battery.
Make sure to observe the correct polarity.
Turning on the power
1. To turn on the power, hold down the MODE button until the
display lights.
2. To turn off the power, hold down the MODE button until the
display goes dark.
The display will blink if the battery has worn down. When this hap-
pens, replace the battery as soon as possible.
Using this device
Press the MODE button to switch between the setting screens for Tempo
(
), Beat (
), Rhythm (
in that order.
Setting the tempo
1. Press the MODE button to display the Tempo setting screen, and use
the jog switch to set the tempo from �� = 30 to 252 min (BPM). Slide
and hold the jog switch to make the tempo continue to change.
Setting the beat and rhythm
1. Press the MODE button to display the Beat or Rhythm setting screens.
2. Use the jog switch to set the beat and rhythm.
Beat: Select a beat from
Rhythm: Select a rhythm pattern from
1 2 3
5
2. Pull the lid diagonally upwards, and
then insert the battery.
), Volume (
), and Pitch (
(0 beat) to
(9 beat).
(Quarter Notes),
(Duplets),
plets:
,
These settings will be stored in the device. However, the settings
will not be stored if the device is not turned off in the ordinary
manner (such as when the battery run out).
Setting the volume
1. Press the MODE button to display the Volume setting screen, and
4
use the jog switch to select the volume from
"Volume: High".
This device's volume has been set to be a little loud, since it may be
used when practicing musical instruments.If the device seems too
6
loud, fasten it to your ear at a position slightly away from the ear hole.
To protect your hearing, avoid using this device for long periods of
time.
Setting the pitch
1. Press the MODE button to display the Pitch setting screen, and use
the jog switch to set the pitch from
High".
Synchronization
The count timing for two or more GM-1 devices can be synchronized.
The GM-1 device that drives the base tempo is called the "source", and
the other GM-1 devices that will follow that tempo in sync are called
"replicas".
This device uses infrared communication when syncing with other
devices. Do not use the sync functions around other devices that
use infrared light, or around plasma TVs.
1. Match the protruding part of the
GM-1 that will be the source to
the recessed part of the GM-1 that
220°
will be the replica, as shown in the
diagram.
2. Press the SYNC button on the
GM-1 that will be the source.
When the synchronization is com-
plete, you'll see the volume shown
on the replica's display.
The tempo, beat and rhythm of the
replicas will be overwritten by that
of the source.
Muting the device
The metronome sounds can be muted.
1. Hold down the SYNC button. Press the SYNC button to cancel
muting.
Display
Rhythm Pattern
)
Tempo: �� =30–252/min (BPM), Beat: 0–9 beat, Rhythm: Quarter Notes,
Duplets, Triplets, Quadruplets, Tempo accuracy: ±0.1, Synchronization
communications method: infrared, Speaker: piezoelectric speaker, Power
supply: 3V lithium battery CR 2032, Battery life: 100 hours (continuous
use at Tempo = 120, Beat =
=
), Dimensions (W x D x H): 49 x 22 x 26 mm / 1.93" x 0.87" x
1.02", Weight: 10 g / 0.35 oz. (including battery), Included items: Owner's
Manual, CR2032 lithium battery (3V), ear caps (S, M, L)
* Specifications and appearance are subject to change without notice for
2
improvement.
(Triplets:
,
,
,
).
"Pitch Low"to
Source

Rhythm Pattern List

Display
Rhythm Pattern
Specifications
, Rhythm =
, Volume =
),or
(Quadru-
"Volume: Low" to
"Pitch
Replica
, Pitch

Publicité

Table des Matières
loading

Table des Matières