Preparation - Bruce Goldsmith Design Wasp Mode D'emploi

It is your dealer´s responsibilities to test fly the paraglider before you receive it. The test flight record of this is on
the last page of this manual. Please be sure that this has been completed by your dealer, to prove that he has
done this. Failure to test fly a new paraglider may invalidate any warranty.
Modifications on the glider
Any modification, e.g. change of line lengths, changes on the speed system causes a loss of air worthiness and
certification. We recommend that you contact your dealer or BGD directly before performing any kind of changes.
Chapter II

Preparation

1) Select a suitable takeoff area determined by wind and terrain, clear of any obstacles that may catch in the lines or
damage the canopy.
2) If your paraglider has been correctly packed, you should take it to the top of the takeoff area, and allow the rolled
canopy to unroll itself down the hill (if on a slope). This should leave the paraglider with the bottom surface facing
upwards, the openings at the downwind end of the takeoff area, and the harness at the trailing edge at the upwind
side.
3) Unroll the canopy to each side so that the leading edge openings form a semicircular shape, with the trailing edge
drawn together as the center of the arch. The harness should be drawn away from the canopy until the
suspension lines are just tight.
Chapter III
Preflight Inspection
The WASP is designed to be as simple as possible to inspect and maintain but a thorough preflight procedure is
mandatory on all aircraft. The following preflight inspection procedure should therefore be carried out before each flight.
1) Whilst opening out the paraglider check the outside of the canopy for any tears where your paraglider may have
been caught on barbed wire or even have been damaged whilst in its bag.
2) Check that the lines are not twisted or knotted. Divide the suspension lines into six groups, each group coming
from one riser. By starting from the harness and running towards the canopy remove any tangles or twists in the
lines. Partially inflating the canopy in the wind will help to sort out the lines.
3) It is particularly important that the brakes are clear and free to move. Check the knot, which attaches the brake
handles to the brake lines. Several knots should be used here or they may get entangled in the brake pulleys.
Both brakes should be the same length and this can be checked by an assistant holding the upper end of the
brake lines together, whilst the pilot holds the brake handles. The length of the brake lines should be such that
they are just slack with the wing inflated when the brakes are not applied. After checking the brake lines lay them
on the ground.
Bruce Goldsmith Design GmbH, Hügelweg 12, 9400 Wolfsberg, Austria
6