Flue; Flue Connector; Combustion Air Supply - Energetec Bullerjan Mode D'emploi

3.2 Flue

The wood-burning stove may only be
connected to a flue which is approved for
solid fuels. For the calculation of the
flue requirements, the values from the
data sheet ( p. 23/24 ) are available.

3.3 Flue connector

The flue must be equipped with an appro-
priate wall lining. The flue tube is inserted
into this wall lining. You will find the
matching flue tubes in the Bullerjan
Fixtures product line – also available online,
at www.bullerjan.de

3.4 Combustion air supply

The Bullerjan dot ® extracts the necessary
combustion air from the place of setup.
At any rate, the place of setup should have a
minimum spatial volume of 4 m
nominal heat output. For the Bullerjan dot
the combustion-air supply is sufficient
if the place of setup has at least one door
leading to the outside ( or a window which
can be opened ) . Please consult your
district master chimney sweep in advance –
at best, during the planning phase – for
more information.
In well-insulated spaces or when mechanical
ventilation systems are present, a supply
with external combustion air may be
necessary. The Bullerjan dot
capacity to connect a supply line for external
combustion air ( e. g. from the cellar or from
outside ) . This supply line must consist of
smooth tubes and feature the corresponding
maintenance flaps at archways.
The installation must be performed soundly.
You will find matching connector tubes
® - in the Bullerjan
available online, at www.bullerjan.de
per kW of
3
® ,
100 mm
offers the
®
® -Fixtures product line – also
Connection for external cumbustion air
29