Troubleshooting - Greenlee ESG105LXR Mode D'emploi

Troubleshooting

Before You Begin
1. Make sure that the battery is charged. Recheck the battery after several minutes to make sure the battery is
holding its charge.
2. Remove battery from tool.
3. Check the tool, see Pre-Operation Inspection.
4. Reinstall the battery and check the tool over again.
Consult the tables below for solutions to troubleshoot possible issues the tool may face. To aid trobleshooting, The
Tool Indicator LED Table (pg. 8) explains signals from the red LED on the tool that may occur.
Tool Operation Troubleshooting Table
Problem Possible Cause
Contaminants in
ram area of tool.
Tool is
inoperative.
Tool parts worn
or damaged.
Low or
uncharged
battery.
Motor is
inoperative.
Broken switch
components.
Oil level low.
Motor runs Air in hydraulic
but tool system.
will not
complete
a cycle.
Cold oil.
Tool loses
Damaged seal.
oil.
52087760 REV 0
Probable Remedy
Clean tool.
Send tool in for
service.
Try known charged
battery. Inoperative
battery may be
discharged or may
have reached life
expectancy.
Send tool in for
service.
Send tool in for
service.
Pull trigger and
hold retract button
together for about
10 seconds,
attempt cut again. If
unsuccessful, send
tool in for service.
Pull trigger and
hold retract button
together for about
10 seconds to warm
oil.
Send tool in for
service.
© 2020 Greenlee Tools, Inc.
Remote Cable Cutter
Tool Error Code Table
Error
Meaning
Code
1 Overcurrent fuse
2 Overcurrent comparator
3 Overheated circuit board
4 Overheated battery
Battery empty; operation
5
stops
6 Faulty cut; complete cycle
Faulty cut; incomplete
7
cycle
8 Low battery
9 Battery empty
Real-time clock battery
10
low
11 Tool deactivated
12 Service necessary
13 Real-time clock not found
14 Bluetooth unit not found
®
15 [Not Used]
16 Pressure sensor not found
17 Pressure exceeded
Battery temperature too
18
low
Remote control battery
21
low
Action
Seek Service
Seek Service
Cool Tool
Cool Battery
Charge Battery
Seek Service
Seek Service
Charge Battery
Charge Battery
Seek Service
Seek Service
Seek Service
1. Re-insert Battery
2. Seek Service
1. Re-insert Battery
2. Seek Service
Seek Service
Seek Service
Warm Battery
Replace Battery
15