Setup; Attaching The Handle - Cart Model Only; Locking And Unlocking The Gun; Attaching The Tip - amspray DSP 1400 Serie Notice D'utilisation

SETUP

WARNING
Do not plug in the unit until setup is complete.
Attaching the Handle--Cart Only
1. Position the handle against the cart so that
the holes in the handle line up with the holes
in the cart.
2. Insert the bolts through the holes in the
handle and cart.
3. Tighten the wing nuts onto the bolts.
Attaching the Pail Bracket--
Cart Only
1. Position the pail bracket against the
unit so that the holes in the unit line
up with the holes in the bracket.
2. Insert the bolts through the holes in
the bracket and the unit.
3. Tighten the bolts.
Locking and Unlocking
the Gun
CAUTION
Always lock the trigger off when the gun is not in use.
Gun models GX-06 and GX-07
The gun is secured when the trigger lock is at a 90° angle
(perpendicular) to the trigger in either direction. To unlock the
trigger, turn the trigger lock to be in line with the trigger.
GX-06/07 Gun locked
(gun will not spray)
Gun models G-08 and G-10
To lock the gun, turn the trigger lock toward the gun handle.
To unlcok the gun, turn the trigger lock so that it is vertical and
pointing down.
G-08/10 locked off
(gun will not spray)
© 2001 Wagner Spray Tech - All rights reserved.
GX-06/07 Gun unocked
(gun will spray)
G-08/10 unlocked
(gun will spray)
Attaching the Tip to the Gun
WARNING
POSSIBLE INJECTION HAZARD. Do not spray without the tip
guard in place. Never trigger the gun unless the tip is in
either the spray or the unclog position. Always engage the
gun trigger lock before removing, replacing or cleaning tip.
1. Thread the spray tip onto the
gun. Tighten the nut first by
hand, then tighten more firmly
with a wrench.
NOTE: When attaching tip to the gun, align the tip
guard as shown in figure below, then
tighten with a wrench.
Begin
tightening
the tip at
this angle

Choosing the Correct Spray Gun Filter

Use the proper gun filter based on the tip size being used.
Part No. Tip Size
0154918 .011
0154675 .013 - .015
0154842 .017 - .023
0154919 .023 and up

Attaching the Paint Hose

1. Be sure that the motor is turned
to OFF (o).
2. Attach the high pressure hose
to the paint hose port. Use a
wrench to tighten the paint hose
securely.
3. Attach the gun to the other end
of the high pressure hose.
Tighten securely with a wrench.
Attaching the Suction Set and Return Hose
1. Attach the suction tube to the inlet valve and tighten firmly
by hand. Be sure that the threads are straight so that the
fitting turns freely.
5
to achieve
the desired
spray angle
when tight.
Filter Mesh Color of Qty.
Type Number Filter
Body
Extrafine 180 mesh red 2 pack
0.084 mm
Fine 100 mesh yellow 2 pack
0.140 mm
Medium 50 mesh white
2 pack
0.315 mm
Coarse 30 mesh green
2 pack
0.560 mm
English