Specifications; Components; General Description; Controls And Functions - amspray DSP 1400 Serie Notice D'utilisation

SPECIFICATIONS

NOTE: This pump is available in two models: a stand
model and a cart model. The stand model is
shown in this manual. All information given for
the stand model applies to the cart model
except where indicated.
Weight ..............................25 lbs. (1400)
31 lbs. (1550, 1700 and 1900)
40 lbs. (2100)
Capacity ...........................Up to .25 gallon (1 liter) per minute.
(DSP 1550 Series)
Up to .33 gallon (1.25 liters) per
minute. (cart model DSP 1700 Series)
Up to .42 gallon (1.6 liters) per
minute (cart model DSP 1900 Series)
Up to .45 gallon (1.71 liters) per
minute. (cart model DSP 2100 Series)
Power source ...................1/2 Hp universal motor (1550 Series)
5/8 Hp permanent magnet DC motor
(1700 series)
3/4 Hp permanent magnet DC motor
(1900 Series)
7/8 Hp permanent magnet DC motor
(2100 series)
Power requirement ...........15 amp minimum circuit on 115
VAC, 60 Hz current.
Generator .........................15 amp A/C.
Spraying pressure ............Up to 2800 psi.
Safety features .................Spray gun trigger lock and pressure
diffuser; built-in tip safety guard;
priming knob for safe pressure
release.
Capability..........................Sprays a variety of paints, oil base
latex, primers, stains, preservatives
and other nonabrasive materials,
including pesticides and liquid
fertilizers.
Unit Tip Size: Supplied Max. Size Supports
1400 .013
1550 .013
1700 .015
1900 .017
2100 .017

COMPONENTS

The shipping carton for your painting system contains the following:
• Suction set and return tube
• Spray gun with filter
• Spray tip assembly
• 25 foot long, 1/4 inch diameter pressure hose (1550)
• 50 foot long, 1/4 inch diameter pressure hose (1700/1900/2100)
• Packing lubricant

GENERAL DESCRIPTION

This high performance piston pump is a precision power tool
used for spraying many types of materials. Read and follow
this instruction manual carefully for proper operating
instructions, maintenance and safety information.

Controls and Functions

ON/OFF Switch ................The ON/OFF switch turns the unit on
and off.
Suction Set .......................Fluid is drawn through the suction
set into the pump.
Fluid Section ....................A piston in the fluid section moves up
English
Spray Gun ........................The spray gun controls the delivery
Spray Hose ......................The spray hose connects the gun to
Return Tube......................Fluid is sent back out through the
PRIME/SPRAY Knob........The PRIME/SPRAY knob directs fluid
Pressure Control Dial .......The pressure control dial controls
Spray Hose
Spray Gun
.015
.015
.017
PRIME/SPRAY
Knob
.019
.021
4
and down to create the suction that
draws fluid through the suction set.
of the fluid being pumped.
the pump.
return tube to the original container.
to the spray hose when set to SPRAY
or the return tube when set to PRIME.
The arrows on the PRIME/SPRAY
knob shows the rotation directions for
PRIME and SPRAY.
the amount of force the pump uses
to push the fluid.
Return Tube
Suction Set
(Rear View,
1400, 1550, 1700,1900)
Pressure Control Dial
© 2001 Wagner Spray Tech - All rights reserved.
ON/OFF Switch
PRIME/SPRAY
Knob
Fluid Section
(Front View, 2100)