Table Des Matières; Safety - amspray DSP 1400 Serie Notice D'utilisation

TABLE OF CONTENTS
SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
COMPONENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
GENERAL DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Controls and Functions . . . . . . . . . . . . . . . . . . . . . . . . . 4
SETUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Attaching the Handle - Cart Model Only . . . . . . . . . . . . . 5
Attaching the Pail Bracket - Cart Model Only . . . . . . . . . 5
Locking and Unlocking the Gun . . . . . . . . . . . . . . . . . . . 5
Attaching the Tip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Attaching the Spray Hose. . . . . . . . . . . . . . . . . . . . . . . . 5
Attaching the Suction Set and Return Tube . . . . . . . . . . 5
Plugging in the Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
PRESSURE RELIEF PROCEDURE . . . . . . . . . . . . . . . . . . . 6
PRIMING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Purging and Priming . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
SPRAYING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Spraying Technique . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Practice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
ROUTINE CLEANING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Cleaning the Spray Gun Filter . . . . . . . . . . . . . . . . . . . . 8
Unclogging the Spray Tip . . . . . . . . . . . . . . . . . . . . . . . . 8
Cleaning the Spray Tip. . . . . . . . . . . . . . . . . . . . . . . . . . 8
Cleaning the Suction Set Screen . . . . . . . . . . . . . . . . . . 8
CLEANUP AND STORAGE . . . . . . . . . . . . . . . . . . . . . . . . . 9
Short-Term/Overnight Storage . . . . . . . . . . . . . . . . . . . . 9
Long-Term Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Daily Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Extended Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . 10
ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
FLUID SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
PARTS LIST. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
SAFETY PRECAUTIONS
This manual contains information which must be read and
understood before using the equipment. When you come to an
area which has one of the following symbols, pay particular
attention and make certain to heed the safeguard.
WARNING
This symbol indicates a potential hazard which may cause
serious injury or loss of life. Important safety information
will follow.
CAUTION
This symbol indicates a potential hazard to you or to the
equipment. Important information that tells how to prevent
damage to the equipment or how to avoid causes of minor
injuries will follow.
NOTE: Notes give important information which
should be given special attention.
CAUTION
THE DSP 1400 AND 1550 SERIES UNITS ARE PROVIDED
WITH A NON-RESETABLE THERMAL OVERLOAD. THE
DSP 1700, 1900 AND 2100 SERIES UNITS ARE PROVIDED
WITH A REPLACEABLE FUSE.
• Always disconnect the motor from the power supply
before working on the equipment.
NOTE: The cause of the overload should be corrected
before restarting. Take to Service Center.
English
WARNING
HAZARD: Injection injury - A high pressure paint stream
produced by this equipment can pierce the skin
and underlying tissues, leading to serious
injury and possible amputation. SEE A
PHYSICIAN IMMEDIATELY.
DO NOT TREAT AN INJECTION INJURY AS A SIMPLE CUT!
Injection can lead to amputation. See a physician
immediately.
The maximum operating range of the gun is 3000
PSI/207BAR fluid pressure.
PREVENTION:
• NEVER aim the gun at any part of the body.
• NEVER allow any part of the body to touch the fluid
stream. DO NOT allow body to touch a leak in the fluid
hose.
• NEVER put your hand in front of the gun. Gloves will not
provide protection against an injection injury.
• ALWAYS lock the gun trigger, shut the pump off, and
release all pressure before servicing, cleaning the tip or
guard, changing tip, or leaving unattended. Pressure will
not be released by turning off the motor. The
PRIME/SPRAY knob must be turned to PRIME to relieve
the pressure. Refer to the PRESSURE RELIEF
PROCEDURE described in the pump manual.
• ALWAYS keep the tip guard in place while spraying. The
tip guard provides some protection but is mainly a warning
device.
• ALWAYS remove the spray tip before flushing or cleaning
the system.
• Paint hose can develop leaks from wear, kinking and
abuse. A leak can inject material into the skin. Inspect
the hose before each use.
• NEVER use a spray gun without a trigger lock and trigger
guard in place.
• All accessories must be rated at or above 3000 PSI/207
BAR. This includes spray tips, guns, extensions, and hose.
NOTE TO PHYSICIAN:
Injection into the skin is a traumatic injury. It is important
to treat the injury as soon as possible. DO NOT delay
treatment to research toxicity. Toxicity is a concern with
some coatings injected directly into the blood stream.
Consultation with a plastic surgeon or reconstructive
hand surgeon may be advisable.
HAZARD: EXPLOSION OR FIRE - Solvent and paint fumes
can explode or ignite. Property damage and/or
severe injury can occur.
PREVENTION:
• Provide extensive exhaust and fresh air introduction to keep
the air within the spray area free from accumulation of
flammable vapors.
• Avoid all ignition sources such as static electric sparks,
open flames, pilot lights, and hot objects. Connecting or
disconnecting power cords or working light switches can
make sparks.
• Do not smoke in spray area.
• Fire extinguisher must be present and in good working
order.
• Place paint pump at a minimum of 3 feet (preferably more)
into a separate, well ventilated room from the spray object
or at least 20 feet from the spray object in a well ventilated
area (add more hose if necessary). Flammable vapors are
often heavier than air. Floor area must be extremely well
ventilated. The paint pump contains arcing parts that emit
spark and can ignite vapors.
• The equipment and objects in and around the spray area
must be properly grounded to prevent static sparks.
• Use only conductive or grounded high pressure fluid hose.
2 © 2001 Wagner Spray Tech - All rights reserved.