Canadian Spa North American 60Hz Mode D'emploi page 4

BASIC: Water is drawn through the drains in the foot well and the skim filter on the side of the spa it is then pumped through a filter, over the
heater, into the Ozone Reaction Chamber and returns to the jets. Finally the water entering the spa has now been filtered, heated and mixed
with air ready for use. Note: A sensor on the heater ensures water flow over the heater before allowing the heater to energize.
JETS: All regular jets can be flow adjusted by rotating the face of the jet. As the jet face is turned clockwise the water pressure will start to
decrease, and when turned counter-clockwise the water pressure will increase.
FILTER: A weir is located on the skimmer. It is used to skim oils and floating pieces of debris from the surface of the spa. (If applicable, the
weir should be facing in to the skimmer opening.)
AIR CONTROLS: Air Controls inject air into the jets via a venturi system. Rotating the left or right control from minimum to maximum activates
the air control.
NOTE: The system functions when your jets are at full power only.
LED Pop-up speaker
1" Air pipe
Ozone
Control
pack
Heater unions
Front access side of spa
* There may be slight differences/variations with each spa and that not every spa is exactly the same.
How your spa functions
Spa operation - Filtration cycle
Your spa exposed (Toronto model)*
Slice valves
2" water pipe 2" Pump
union
2.5" Pump
union
Owners Manual
LED Pop-up speaker
5" Jet body
Water manifold
Pump
Rear side of spa
3
Shell insulation foam
2" Jet body
3" Jet body
Filtration housing