Kemper FK-5 Instructions De Montage page 5

Safety instructions for installation, maintenance and operation
Warning! Always connect an expansion vessel PN10
with min. 33 liter to the pressurized secondary outgoing
pipe. The pre-charge pressure of the expansion vessel
must always be 0.5 bar below the cut-in pressure of the
FK-5.
Important notes for the system plumber
Power supply
Electrical power input
Electrical power
Power factor
Protection class
Medium
Ambient temp., max.
Ambient temp., min.
Inflowing medium, temp. max.
Inflowing medium, temp. min.
Flow pressure, max.
Flow pressure, min
Pressure stage
Outlet pump pressure
DU value
Flush volume of PWC line
(at 3 bar)
1. Only use the device
- in sound condition
- as intended
2. Parallel installation of two or more break tank
stations is not permitted.
3. It is essential that the specified maintenance intervals are kept.
230 V AC
DN 20: 3.3 A
DN 25: 5.5 A
DN 20: 759 W
DN 25: 1265 W
0,97
IP 54
Water
40°C
2°C
35°C
2°C
DN 20/DN 25: 4 bar | 0.4 MPa
DN 20: 1 bar | 0.1 MPa
DN 25: 1.5 bar | 0.15 MPa
PN 10
DN 20: 4.3 bar | 0.43 MPa
DN 25: 5.9 bar | 0.59 MPa
DN 20: 0.83 l/s
DN 25: 1.67 l/s
10 l/min
Warning! Under no circumstances must any water
drawn be used as drinking water - even in small
amounts!
Warning! Following the installation, addition of accessories or
maintenance, all feed lines must be flushed according to
DIN EN 806-5 and VDI/DVGW (Association of German Engineers/
German association for gas and water) 6023.
Liability
No warranty or liability will be accepted in case of:
- Non-compliance with the instructions.
- Incorrect installation and/or operation.
- Unauthorised modification of the product.
- Other incorrect operation.
Disposal
Local regulations on waste recycling and disposal must
be followed.
The product must not be disposed of with household
waste but must rather be disposed of in accordance with
local regulations.
© www.kemper-olpe.de – 11.2021 / K410036900022-00 – 5 / 60
EN