Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2610051568.qxp_GSR12V-300 12/19/18 1:15 PM Page 9
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the
tool accidentally.
▶ Inserting and Releasing Battery
Pack
Release battery pack from tool by pressing
on both sides of the battery release tabs
and pull downward (Fig. 2 or 3).
To insert battery, align battery and slide
battery pack into tool until it locks into
position. Do not force.
otherwise damaged, do not insert into
tool. Battery can fall out during operation.
▶ Inserting Bits
Move reverse switch lever to the center
"OFF" position. Remove battery pack and
rotate the clutch ring to the drill bit symbol
"
". Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and
open chuck to approximate drill bit
diameter. Insert a clean bit up to the drill
bit flutes for small bits, or as far as it will
go for large bits. Close chuck by rotating
the chuck sleeve clockwise and securely
tighten by hand (Fig. 4).
chuck to loosen or tighten bit. Friction
burn or hand injury is possible if
attempting to grasp the spinning chuck.
▶ Belt Clip and Bit Tip Holder
Bosch GSR12V-300 comes with the option
to use a metal belt clip and a four piece bit
tip holder. Pry off the plastic cover from
the back of the drill to install these
accessories (Fig. 6).
▼ BELT CLIP
position yourself to avoid entanglement
with surrounding objects. Unexpected
entanglement could cause the tool to fall
resulting in injury to the operator or
bystanders.
Assembly
Disconnect battery pack
from tool before making
If battery release tabs
are
cracked
Do not use the power of
the drill while grasping
When
the
tool
attached to the belt,
Fig. 2
Fig. 3
or
Fig. 4
DRILL BIT
Fig. 5
is
The belt clip will allow you to conveniently
attach your tool to your belt. This feature
will allow you to have both hands free
when climbing a ladder or moving to
another work area.
9
BATTERY
RELEASE
TABS
BATTERY
RELEASE
TABS
CHUCK SLEEVE
BIT HOLDER
SCREWDRIVER BIT
Publicité
Table des Matières
