Valor PORTRAIT President 536CXB Guide D'installation page 6

Installation
1. Fit the top baf e under the top panel of the appliance
case. Secure with 2 thread forming screws.
2. Fit the stand-off spacers. The stand-off spacers for
these installations are supplied  at. They are left and
right handed.
! Warning: Failure to install the stand-off spacers
may result in a fi re hazard.
a) Remove the 2 screws near each of the rear top
corners of the appliance and the 2 screws near
each side of the top back corners.
b) Bend the spacers as shown.
c) Screw the spacers to the rear of the appliance
using the screws just removed.
d) Bend the side wings of the spacers to align the 2
holes in each spacer with those in the appliance
sides. Secure the spacers using the screws just
removed.
3. Mount the framing plate to the appliance.
6
4. Secure the framing plate and brackets to the sides
of the appliance case with 4 thread cutting screws
supplied.
Screw from the outside through the access holes in
the framing plate.
Note: There are
alternate methods of
 nishing around the
framing plate——either
leaving it exposed
or recessing it and
covering it up with the
wall  nish. See page
4.
5. Install the plinth and the rear base support below
the  rebox (optional).
The purpose of the plinth is to allow the appliance
to be placed on a rough sub oor, such as plywood,
without regard for the additional thickness of  oor
 nishes as the appliance bottom must otherwise be
placed at the  nished hearth height or the front trims
will not  t properly on the appliance.
a) Detach the burner module from the appliance
by removing its 11 screws.