11. Melody selection with radio extension kit
If a radio module (radio extension kit, not included) has been inserted
into the slot then melody selection takes place via the transmitter
(Fig. 5).
Slide switch : K1 – for 3-sound-tone, K2 – for Westminster-melody,
K3 – for polyphone melody
Slide switch : „SEQ" - for alternating melody at K3;
„SET" – to use a selected melody at K3
If slide switch is at K3 then the gong plays a defined polyphone melo-
dy or alternating polyphone melodies.
Pushing the slide switch to „SEQ" enables you to select the desired
polyphone melody by pressing the transmitter. To ensure that the gong
only plays this selected melody the slide switch must be pushed to the
„SET" position without having pressed any other buttons in the me-
antime. If the slide switch remains in the „SEQ" position any random
polyphone melody is played.
Note: On changing the battery or changing a module respectively the
melody is automatically reset to a standard melody and must be reset if
necessary.
12. Adjusting the volume
Four different volumes can be selected in stages by pressing the „VOL "
button (1) in the gong.
Note: On changing the batteries or changing a module respectively the
volume is automatically reset to „LOUD " and must be adjusted if re-
quired.
13. Operation with sound module
By using the sound module (not included) additional polyphone melodies
or sounds can be played when in the „T3"/„K3" mode. Insert the sound
module into the expansion slot (Fig. 3) and carry out the melody selection
as explained in point 8 / 9.
20