Bio Green HK 4.3 Mode D'emploi page 11

Heating Cable HK
The length of the heating cable cannot be altered. If it is shortened,
there is a risk of overheating; if it is lengthened, it will no longer be able
to generate the required amount of heat. Any attempt to physically alter
the heating cable will render the warranty invalid. The heating cable is
irreparable once it has been cut.
The heating cable must be protected against wear if it is installed in a
location where it may be damaged (e.g. rodent damage, risk of falling
icicles, etc.)
The heating cable may only be connected to a 230 V ~/50 - 60 Hz AC
power source. It must be protected against extreme dirt and
contamination. Any use other than that described above may result in
damage to the heating cable and is also hazardous, with the possibility
of short circuiting, fire, and electric shocks, etc. The safety and
installation instructions must be followed at all times.
3. Safety and Hazard Information
•
Only a 230 V ~, 50/60 Hz mains socket connected to the public
mains supply should be used as the power source. Never try
running the device off a different voltage.
•
If you have any doubts about the way the device is operating, its
safety or its connection to the mains, you should contact a specialist
electrician.
•
Never connect the heating cable to the mains when it is coiled up.
This can result in damage to the cable due to overheating or fire.
•
The length of the heating cable must not be altered.
•
The minimum bending radius of the heating cable (1 cm) must be
observed.
•
When working on the heating cable or in the vicinity of the heating
cable, the device must be disconnected from the mains supply.
•
You should never connect or disconnect the mains plug with wet
hands.
•
Do not pull on the mains lead itself, but always grasp the grip
surfaces of the mains plug to remove it from the socket.
11