emerio FN-120952 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
and tighten. (fig. 2)
3) Slide the fan blade onto the spindle ensuring the screw is lined up with the "flat" surface on the spindle as
shown. (fig. 3)
4) Push on until the end of the spindle is flush with the end of the fan blade hole, then tighten the screw. (fig.
4)
5) Open up all locking clips on the sides of the front guard. (fig.5)
6) Place the front guard into position by lining up the location plate over the top of the rear guard as shown
and push down. (fig.6)
7) Secure the two guards by closing the clips over the outer rim. (fig. 7)
8) Then using the small nut and bolt, fasten the two guards together at the bottom of the guards. (fig.8)
OPERATING INSTRUCTION
1.
Plug the power cord into a suitable socket.
2.
Switch on the fan by using the speed switch on the motor housing. "0" = off, "I" = low speed, "II" = medium
speed, "III" = high speed.
3.
Tilting angles: You can loosen the big and small black knobs on the motor bracket to adjust the fan to your
preferred elevation. Then fasten the elevation by tightening the knobs.
4.
Oscillation: to make the fan head oscillate, push down the oscillation knob on the top of the motor. To stop
the fan head from oscillating, pull up the oscillation knob.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3.
Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally
using a dry brush or vacuum cleaner.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption:
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has occurred
during production or transportation, please return the device to your dealer. In addition to statutory legal rights,
50W
- 5 -

Publicité

Table des Matières
loading

Table des Matières