emerio FN-120952 Mode D'emploi page 5

FN-120952
PARTS DESCRIPTION
1. Fan guard
2. Fan blade
3. Motor
4. Oscillation knob
5. Speed switch
6. Height adjustment pipe
7. Fastening knob
8. Tripod holder
9. Tripod leg
10. Butterfly fastening screw
11. Metal link pipe
ASSEMBLING INSTRUCTIONS
** Please assemble correctly by the following orders when using.
1. Tripod leg assembly
1) Remove the securing screws and nuts from the tripod holder.
2) Attach the metal part of the wooden tripod leg to the tripod holder, line up the holes and fit the securing
screws all the way through. Take note of the orientation of the leg end.
3) Fit the nut to the protruding end of the screw and tighten the nut.
4) Repeat for the other two legs.
5) Take the butterfly fastening screws out from the small bag.
6) Open out the legs, connect the three metal link pipes by the butterfly fastening screws.
7) Adjust the height adjustment pipe to your desired height and tighten the fastening knob.
2. Motor housing assembly
1) Stand the Tripod on the floor.
2) Remove the big black knob (3) and mounting bolt (2) from the top of the adjustment pipe. Unscrew the knob
and pull the bolt straight out.
3) Loosen the small screw (1) and small black knob (4) from the bracket
on the motor housing.
4) Sit the motor housing on top of the adjustment pipe, insert the
mounting bolt (2) through the bracket and the pipe. Note: the Square
section under the head of the bolt must be aligned with the square
hole in the bracket.
5) Pay attention to screws' position according to the below picture.
Tighten the small screw (1) into position and screw in the small black
knob (4) but do not tighten. Then, fit the big black knob (3) to the
mounting bolt (2).
6) Adjust the tilt angle of the fan head to your desired position and then fully tighten both the small and big
black knobs.
3. Fan guards and blade assembly
1) To assemble the fan guards and blade, first remove the 4 rear guard fastening screws from the motor. (fig.
1)
2) Fit the rear guard into position (with the handle on the back of the guard at the top) and refit the 4 screws
- 4 -
EN