Fig. 17 - Honeywell EFY-041 Série Manuel Du Propriétaire

BATTERY INSTALLATION/REPLACEMENT INSTRUCTIONS
A. Separate the front and rear housing by inserting a small coin into the two recessed
slots located on the bottom of the remote (Fig 14). Twist the coin until the housings
separate. Pull the remote open, separating the halves (Fig. 15). This will
automatically force the lens cover to dislodge.
B. Insert 2 AAA batteries into the remote following the directional guides in the recessed
slots (Fig. 16).
C. Snap the remote together by lining up the front and back and firmly pressing
together.
Fig. 14
Coin
NOTE: DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX ALKALINE, STANDARD
(CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
Fig. 15 Fig. 16

Fig. 17