Philips Lumea BRI861 Mode D'emploi page 22

22
English
Note: When the 'ready to flash' light starts
blinking orange, your skin is not suitable for
treatment. In this case, the device automatically
disables. You can try to use the device on other
areas with a lighter skin tone.
Note: If the ' ready to flash' light does not lights
up green, the device is not completely in
contact with your skin.
TIP: If you use Lumea on your bikini area and
want to leave some hair in place, make sure
that the skin tone sensor is not placed on the
remaining hair during the treatment, as this can
cause the device to block
6 Press the flash button to release a flash. The
devices makes a soft popping sound. You
should feel a warm sensation because of the
flash.
Note: The scattered light produced by the
device is harmless to your eyes. It is not
necessary to wear goggles during use. Use the
device in a well-lit room so that the light is less
glaring to your eyes.
7 Place the device on the next area to be treated.
After each flash, it takes up to 2.9 seconds until
the device is ready to flash again. You can
release a flash when the 'ready to flash' light
lights up green.
8 To make sure that you have treated all areas,
release the flashes close to each other.
Effective light only comes out of the light exit
window. Part of the device that is in contact
with your skin is slightly larger therefore there
should be some overlap. However, make sure
you flash the same area only once.