Drive DeVilbiss Healthcare Litec 2G Plus Manuel D'utilisation page 13

Adjusting seat depth
When delivered, the seat depth of all models is 42 cm. The
depth can be adjusted in 3 positions up to 47 cm.
Please open the Velcro straps (Picture 10) and fold the front
piece of the cushion forward. (Picture 11).
In order to adjust the seat depth, please remove the two
screws on the front of the tube on both sides (Picture 12).
You can adjust the seat depth by pulling it foward 3 times
to the next drilling, then insert the screw and tighten them.
(Picture 13).
Make sure all screws are installed and tightened!
Fold the seat cushion back and fasten the Velcro straps.
10
12
Adjusting backrest and cushion
The degree of hardness can be individually and variably
adjusted by the 5 Velcro fasteners (loosen and tighten)
(Picture 14).
In order to mount the back cushion, please lay the cushion
on the wheelchair as depicted (Picture 15) and unfold it. Part
1 goes on the inside of the backrest, part 2 on the outside
(back), and the 3th part goes under the seat. This will be
fixed automatically by the integrated Velcro straps. (Picture
16+17).
14
Drive Medical GmbH & Co. KG | As per: 13.02.2019 | Subject to error and change
11
13
15
1
2
3
16
Adjusting height of backrest
The height of the backrest may be adjusted in 3 positions
from 42 cm – 46 cm.
Please note: When adjusting the height of the backrest, the
push handles are adjusted as well.
Make sure, that both sides are adjusted correctly and
on the same height.
Adjusting armrest
When delivered, the armrest are already mounted to the
wheelchair. The armrests are replaceable.
Depending on your requests, the armrests can be set as
short or long armrests.
The spring button must lock into position after adjust-
ment. Select the next position if necessary.
EN
17
Loosen the knurled nut on
the left and right side (Pic-
ture 18), on the bottom of the
guide tube attached to the
backrest. Remove the screws.
Adjust the height by pushing
or pulling the push handles
into the correct position. In-
stall the screws and tighten
the knurled nut.
To set, press the spring
button in the middle on the
outside of the armrest (Pic-
ture 19) you can now push
the armrest into the desired
position. (Picture 19).
Tighten the screws again!
The armrest can also be
adjusted in height by pres-
sing the spring button in
the middle under the arm-
rest (Figure 20) you can
now pull the armrest up
and / or down until you
reach the desired position.
13
User Manual Litec 2G Plus